Hi Art...
I just uploaded a photo of a problem I've been chasing today. Could
you take a look at it and tell me if you've seen this before? I am
cutting a 3/8 slot with a 1/4" bit. The slot width is perfect, but
the radius in the bottom of the slot is not right. It should be a
3/16" radius. You'll see what I mean in the picture.
Other arcs seem to be cutting fine. This part is a 5" circle with 3
slots cut in it 90 degrees from each other. The 5" circle is
perfect. Do I have an acceleration problem?
Thanks...Ross
