¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io

Re: tool offset


 

it did put an icon on the desktop but mine is so full of crap i missed it and not knowing what it was called i did not find it in the start menu. i installed it on my router and since the desktop is almost empty i found it immediately. the installer did not ask? but it did an icon. and on this test computer it definitely did not show up in the recently installed list or i would have found it immediately.

On 5/12/2021 2:51 PM, Ron Ginger wrote:
The installer should have asked if you wanted an icon on the desktop. If not I guess you should look in the windows start menu.

ron ginger


On 5/12/2021 12:12 PM, spencer@... wrote:
I installed the wizards and the process seemed to complete but nothing shows up in the recently added programs list and i can not find the newly installed programs anywhere? Any hints?

On 5/12/2021 4:54 AM, Ron Ginger wrote:
On 5/12/2021 12:31 AM, spencer@... wrote:
i installed the wizards, where do i access them?
They are a separate program you cannot call them from Mach. But you can transfer the gcode directly into mach.

We made them a separate program so they could be used with other controllers- even linnuxcnc, or Mach3. I was careful to generate very basic gcode so they should be controller independent.

ron ginger








--
Best regards, Spencer Chase
67550 Bell Springs Rd.
Garberville, CA 95542 Postal service only.
Laytonville, CA 95454 UPS only.
Spencer@...


(425) 791-0309

Join [email protected] to automatically receive all group messages.