I installed the wizards and the process seemed to complete but nothing shows up in the recently added programs list and i can not find the newly installed programs anywhere? Any hints?
toggle quoted message
Show quoted text
On 5/12/2021 4:54 AM, Ron Ginger wrote:
On 5/12/2021 12:31 AM, spencer@... wrote:
i installed the wizards, where do i access them?
They are a separate program you cannot call them from Mach. But you can transfer the gcode directly into mach.
We made them a separate program so they could be used with other controllers- even linnuxcnc, or Mach3. I was careful to generate very basic gcode so they should be controller independent.
ron ginger
--
Best regards, Spencer Chase
67550 Bell Springs Rd.
Garberville, CA 95542 Postal service only.
Laytonville, CA 95454 UPS only.
Spencer@...
(425) 791-0309
