From: "'Andre Schoonbee' andresch@... [mach1mach2cnc]" To: mach1mach2cnc@... Sent: Saturday, February 14, 2015 10:45:44 AM Subject: RE: [mach1mach2cnc] Re: Rapid Safe Z
Hi
?
This will set the limit, but where do I define the distance the router will lift from the workpiece when moving during the form one location to the next. Because I set my Z-Zero on top of my table and not the top of the workpiece.? As I said earlier. Currently my spindle lift about a clearance of 80mm above the workpiece, leaving only 2mm till maximum z- travel limit.
?
From: mach1mach2cnc@... [mailto:mach1mach2cnc@...] Sent: 14 February 2015 03:26 PM To: mach1mach2cnc@... Subject: [mach1mach2cnc] Re: Rapid Safe Z
?
?
Config Ports and pins Safe z Set safe Z to whatever
This email is free from viruses and malware because protection is active.
