开云体育

I need to add a noise generator to the model of a sensor (simply a behavioral source), in order to perform some noise analysis. Noise is described by a noise density and a 1/f corner. which is the

Hey, i am sophomore at the university, and i have a circuit sketch and data sheet. However, i dont know how to use LT Spice effectively. i couldnt build the circuit on LT Spice perfectly. Could you

Hi, I need an BSS138 in my LTSpice simulation. Since I can't find that component in the program itself, I need to make it. I have done the following steps but LTspice won't simulate: 1) Downloaded a

Dear Sir, Will you please tell us how to do it? There might be cases when it is not such a bad idea. Best Regards E.A.Neonakis

Thanks for that, although I use the Linux version of the Adobe reader for viewing PDFs. and LTspice is now the only Windows app that I use on a regular basis. However, I'd like to try it on .net, .cir

--- In LTspice@..., "analogspiceman" <analogspiceman@...> > You can more or less do this now if you know how, but it is a Well, I wouldn't go so far as to say "really bad", just

Thanks.. I usually count on only 40 db from differential stuff or 1% matching.. 0.1% is achievable with a lot of attention to layout When I get time I will read his postings in detail. It reinforces

Hi AG, You may want to read through a series of articles by Kendall see post# 30118 I know that he wrote a test suite for opamp models that tried to include PSRR / CMRR etc. I think this was about

Could someone let me know where I can find spice models for both 1N5811 and 1N6618? Thanks, Dan

Hello Steve, Apologies for the earlier comment. I found your files in Files>Temp>AD8336, but there was no announcement or indication from you that they were there. You schematic wouldn't run, but not

A suggested starting point is the following pdf. See: <http://www.edn.com/archives/1998/081798/pdf/17ms406.pdf> Howard

I know about time step control and its deviousness...! I think minimum time step size puts an u necessary computational burden when little or no activity is present.. it is better to have variable

Andy, Assuming your PIC puts out a PWM signal, the simplest way to do this is to use 4 voltage controlled switches (SW). The front ends of the switches can be configured to switch on and off as

Hello Rick and All, Well, it seems to be operating properly now, in that the "Skip" file shows up, though the .savebias command is still commented out in the log file. I spent several hours yesterday

I am in the process of designing a motor controller circuit. A PIC microcontroller will create/control a PWM signal which will be "inputted" to an H-bridge controller which will drive a brushed DC

Thanks.. Much obliged. Cheers A. Ganesan

You may want to look at Intersil's AN1556. See: <http://www.intersil.com/data/an/an1556.pdf> The author makes this claim about his method "Finally, Accurate SPICE Models I can Understand and Modify to