开云体育

Hi, : Execuse me, May I ask a question about "SMPS transformer behavior in B-H hysteresis curve" ? I had uploaded a picture file at: https://groups.yahoo.com/neo/groups/LTspice/files/%20Temp/SMPS

Hello PhB, I brought the code for the Schematic Builder program in today. It is a little large for this group, but maybe I could upload it to the LTspice files group. I noticed that I wrote it with

Hello Eetech00 You wrote : "I run it on W10 with no problems... " Did you succed to save the schematic created by SchBuilder ? I don't use linux but native windows. Regards PhB

Hello Eetech00 Thanks for your answer. I am a little bit disappointed by it -:) I hpoe Analogspiceman could give me more details on the popup windows I see. Regards PhB

A few days ago, Jeff asked: "Is there a "place" that has the definition of all the parameters of components, vto=-3, lambda=1.2e and such?" The Help pages that come with LTspice are the reference for

I run it on W10 with no problems...

Hi , Are you running it as administrator? W10 is picky about such things. Dave N Sent: 11 August 2016 12:26 To: LTspice@... Subject: [LTspice] Re: SchBuilder.exe Windows10 Hello John " Is

That indicates an internal issue in SchBuilder.exe, probably about compatibility with Windows10. With best wishes DESIGN IT IN! OOO – Own Opinions Only <http://www.jmwa.demon.co.uk/>

Hello John " Is there an option to set which folder to save to? " Yes, SchBuilder offers you to choose your directory. SchBuilder is installed in a private partition (not C:) and I try to save the

Hello Helmut. LTpowerCAD II design only monolithic buck step-down regulators. SwcadIII design step-down and step-up regulators. Bordodynov. 11.08.2016, 13:30, "helmutsennewald@... [LTspice]"

It looks as though the program tries to save in a Windows protected location. Is there an option to set which folder to save to? With best wishes DESIGN IT IN! OOO – Own Opinions Only

Hello Александр Бордодынов and Helmut Thanks Regards PhB

Hello Analogspiceman Did you (or somebody else) try to run schbuilder;exe under W10? When I run it , at the moment when I try to save the schematic I have apop windowwih: " Unable to create file " "

Hello PhB Bododynow talked about this version. https://groups.yahoo.com/neo/groups/LTspiceFiles/files/LTspice%20with%20Synthesizer%202.19k/

Thanks for this! :)

I think it's useful to add, once again, that Helmut is not affiliated, in any way, with Linear, or Mike, nor is it this group, for that matter. -- Vlad ______________________ ltspicegoodies.ltwiki.org

Hello PhB. The team was in SwcadIII menu. Activate this command was issued table (form) to enter the input voltage and load current. By entering the data you need and activated, you will get a table

Hello Bordodynov You wrote : " Old SwcadIII had the opportunity to build the circuit on the input requirements for DC / DC. " I don't see what you mean to say about this possibility ( in SwcadIII and

Hello Andy. I am with you a little bit do not agree. Old SwcadIII had the opportunity to build the circuit on the input requirements for DC / DC. Recently, I studied my old files on CDs and found that

Hello Steve You wrote : " With (2) and (3) LTspice points me to a problem that doesn’t exist and not to where the problem does exist. " A/ You are wrong for case (2) [ mixed Qd44 and 2sc ]. There is