开云体育

Hello AG, I have uploaded the same plotted with the free DPLOT95. It correctly shows the bins. Files > Temp > mc1000_01.gif Files > Temp > mc_distri.asc RUN mc_distri File -> Export Start DPLOT95 Open

Depending on how Tony did, bin 900 includes 895-905 or 900-910. I would expect roughly 250 or 500 occurences... Cheers AG You are right!... I have never won the lottery. .

In message <4E7B459B.9050806@...>, dated Thu, 22 Sep 2011, Ganesan <dg1@...> writes: 900 is the number of the secret winning ticket that wins 70 million dollars. So it's not

Thanks Helmut. That explains why I've never encountered it. I'm in the habit of checking

Hello AG, I'll check the data this evening. I strongly suspect the bias issue is "operator error". I quickly threw it together this morning. I exported the plot data from LTspice, and imported it as a

Hello alltogether, I want to simulate the LED backlight of a display and need help: I only have values of the LED voltage and current. Is it possible to simulate with these few parameters the

I have been in the IC design business for over 30 yrs and in the component circuit design business for over 20 yrs. Exceeding the safe operating limit of a device even for a few pico seconds every

Hello Emmanuel A.Neonakis, You have it. An SMPS-IC with steady-detector is sufficient. Please try this example. Files > Examples > SMPS > buck_boost_efficiency.zip

I think I'll chime in on this one... It appears that what you want to do is perform

Dear Mr Sennewald, Is it necessary that the SMPS-IC from LTC is part of the design, or does it suffice that the IC is just present and trivially connected? If that is the case will you please be kind

I didn't get a confirmation ; so I am sending it again..

Hi Tony, In 10000 iterations the value 900 never seems to show up.. Is this a binning issue of the histogram or is there a bias in the "MC " function? "mc(val, tol) is a function that uses a random

Hello Ian, LTspice checks Iave and Vpk when you run a simulation with an SMPS-IC from LTC using the "steady" option in ".tran". If the limit is exceeded, the diode will be marked with a black

Hello Alex, Thanks for your advice, I hope it helps someone. I tried setting Delta to 0 and 1, in the Si4500B example, and confirmed by looking at the data that there was almost no difference. The

Hi Tony. I have for you is good advice. It applies to models of transistors. I recommend to remove the parameter DELTA. This setting adjusts the threshold of the transistor when the transistor width.

Hello Pascal, I don't particularly want to single you out for criticism, even though I obviously seem to be. For each of these devices, the manufacturers provide SPICE models for both N and P channel

Hello, I had sent the version Ring_2.zip to Mike and asked for an advice. He came back with the solution. --- from Mike --- There's an error in the way the library is set up. Remove ".lib 035a.lib"

Hello AG, By default, the seed is the same each time, so the MC series is repeatable. However, there is an option to randomise the seed. This was discussed in detail here quite recently; check the