开云体育

Thanks Tony, my bad! you do need to use CNTL-right click to get the required menu -robert

In message <j4pek9+j80b@...>, dated Wed, 14 Sep 2011, sepulchre10 <sepulchre10@...> writes: There are just too many different parts. If you want to simulate using specific catalogued

Hello Ken, That's probably for two reasons: because LTspice was/is primarily intended to evaluate switchmode power supply chips, capacitors appropriate to that application are supplied. The other

If you need the extra info, then you probably already have a capacitor picked out. So use its datasheet to fill in the blanks. Otherwise just edit the value. -- Nick [Non-text portions of this message

<snip> </snip> Hello Robert, I think you mean ctrl-right-click. For the NMOS symbol, you don't get the component attribute editor unless you do this, you get the "choose new MOSFET" dialogue. For the

Hi AG, I would caution against using a simple E source based fully differential amp model. Usually G source with appropriate resistor results in a much better behaved model. I believe I suggested you

When I look in the list the smallest shown is 0.5uF. When putting together a schematic with smaller caps, eg. 470pF I don't know any of the info on them other than the value. I see that the ones in

Hi Tal, If you right click on the device, you should get the "component attribute editor" window the Prefix will be MN, change this to XN. The Value NMOS needs to be changed to match the subcircuit

I am re-posting this since I din't get a boo or an aye or nay.. Cheers AG

I am re posting this since I didn't get aye or nay... Cheers AG

Hi KMR, I think the nearest you are going to get to a CD4060 LTspice model is by using a CD4020 which is similar to the CD4060 but the CD4020 has not got an attendant oscillator. You can remedy this

Maybe substituting with A models and Helmut's expertise will get him over the hump.. It did for me.. Thanks everybody.. Cheers AG

Ganesan, PSPICE logic devices or primatives won't wotk with LTspice. RICK

http://www.orcad.com/forums/ShowPost.aspx?PostID=14705 * 31 Oct 2006, 1:39 AM doom49 Joined on 10-14-2006 Posts 4 A model for CD4060 CMOS 14 Stage Ripple-Carry Binary Counter/Divide I am not

Perhaps you should try a Pspice forum? This is a group for LTspice. I feel sure that if you looked in the Files section of the group site, you would probably find information that might help you.

Hello Axel, Running four instances of LTspice from a bash shell is not a problem, but I don't think it's possible to open two files at once, either in Windows or Linux, from the command line. I've

Let s take a simple 2 resistor divider and a battery I want to step one of the resistors by 1% or 10%.(small change sensitivity v. large change sensitivity ) I want to plot

Hello to all, Please stop the discussion about Pole Zero Analysis. It has been beaten to death. It's totally off topic now. Best regards, Helmut Moderator

Hi *, In Ubuntu with Wine I want to have a setup of 4 LTSpice GUIs started together. I'd like to have a schematic and a .cir file loaded for every instance of LTspice. Does anybody know how to load

<snip> </snip> Yes, I knew that sooner or later you would send this discussion into a siding. :-) Going back to Peter Baxandall: the man was a genius, and all done without Computer Aided Disease - er,