开云体育

Good to know. As it must. How much is "too much"? So therefore it provides less than 500 W to the load, right? But some of that current into the primary represents reactive power, not rea

You get that from the foundry you plan to use to make your device. LTspice doesn't have that information. -- This email has been checked for viruses by AVG antivirus software. www.avg.com

They have been discussed here a number of times, including these: /g/LTspice/files/z_yahoo/Files%20sorted%20by%20message%20number/msg_21060

What version allowed the sim to run without stalling? I am now using 24.1.8, and the sim stalls after a different number of microseconds , depending on which tweak I have made to the .ASC.? I don't

Hello guys, Does anyone has 90nm CMOS technology text file or link something like that. Absolutely for LTspice.

My simulation did not stall.? It is somewhat slow and I did not wait 100ms for it to finish, but it never stalled.? That might be because of different Control Panel settings, or it might be because

Your messages are somewhat confusing. Of course the inductances should be in uH (micro Henrys), not us (micro seconds), but we get the idea.? I may not understand what you meant by "steady".? I'm

Ooops. Still not having it. I shall sleep on things and try again tomorrow.

Apologies for setting things off and thanks for the additional replies. I upgraded to 24.1.8 and now it is working. I did have {MOS} set as the mosfet type for M1 and M2 in my subcircuit so it just

Ich habe die ltspice-Datei unter dem Namen M2C single-phase SPWM112 auf Temp hochgeladen

Alright, Anyone else who can help

Hi folks, I am new in the forum and I think I have done already some real big magic in LTspice but now I struggle how I can add a chip internal digital filters after an ADC to my huge analog model of

As part of my studies, I have to simulate a single-phase modular multilevel converter MMC (3-level) on Ltspice. I have already connected the circuit with two voltage sources of 20V each, two

On 06/05/2025 18:41, Andy I via groups.io wrote: > On Tue, May 6, 2025 at 09:33 AM, Tony Casey wrote: > > Assuming you want to calculate the average inductor current: > > .MEAS Imax max I(L_filter_dc)

You have a huge inrush current due to the capacitors being fed from a zero-impedance source V9. Put 1 ohm in series with it. But the simulation still stalls without an error message after less than 1

I've updated my file with the name Dabnew.asc in TEMP folder kindly someone fix the current issue of my primary side transformer of DAB

yes I've changed my inductance to 110us, 250us, 1us but current is still high around 40A. and it is steady

You can't change L1 without also changing L2, keeping their ratio constant. It would be OK to change L3 by the same factor. So try L1=110? L2=250? and L3=1?.? It doesn't make much sense to specify

Thanks for replying. i put 11us so it made my output 150 if i increase 11us to above it changes the output I've uploaded my file in TEMP with the name of dabhw4_new can you tell what should i do

Andy, Understood. And that's a horrible mistake on my part. I am sorry about it. Not offending anyone. Old times were good and simple, not many were offended about a him/her/their. People have