开云体育

Hi, I am looking for an Op-amp with these descriptions. I would really appreciate it if you help me find a proper model. 200 V 3~30KHz

Here is one more suggestion, which I'm putting here because it might help everyone. In Grroups.io, when you see a button to "Leave Group", it means to permanently leave the group = unsubscribe from

Tony, I agree. Shame that the current On-Semi data does not provide an I-V plane plot. All that said, however, a circle back to small signal data set is still useful and unfortunate in many cases that

I admire your dedication to S-parameters, but I can't help thinking going via Y-parameters (which are rarely given in modern datasheets) is more work than der

Andy, I'll be glad to share data. As my time permits I will search for what I have and post. This was done quite some time ago. Many of the files are on a HP Winchester CS 80? drive which was

Alan, So, I guess you are unwilling to part with the 2N3904 data? Why didn't you just say this? Andy

Michael, let's take this discussion offline. Please send further communications to the LTspice+owner email address. Whatever you keep doing when you login to your account, you need to stop doing

Michael, your Groups.io account has no Bounces.? I guess you are receiving Bounces for another account that you didn't tell us about. Andy

Ok, changed the password for Preh.de address. (I am using chrome now, before it was edge or IE) The Yahoo address is also mine for private use. The Micron address is not mine and never was. The

Michael, stop unsubscribing yourself! Whatever you are doing on the web, logged in to Groups.io, you are unsubscribing yourself.? Stop doing that! " I guess I need help from mail admin of Groups.io.

Michael, You wrote that your gateway always bounces the first message from unknown mail servers.? IMO, this is a really BAD idea.? But anyway, it shouldn't matter, because by now your gateway knows

On 2/23/21 10:13 AM, haubmi1 via groups.io wrote: > I have seen parts of the logs of our mail gateway. > And I suspect following scenario: > > -> from: [email protected] <mailto:[email protected]> >

Hi Andy, Yes, allows conversion to S. As far as the 3904, the data I have I measured from a variety of manufacturers. The conversion from manufactured y or h and a comparison to measured S of the same

Michael, The reason why your subscription is Daily Summary again, is because you unsubscribed and re-subscribed yourself, AFTER Tony made those changes. Stop doing that! You are set (again) to receive

I have seen parts of the logs of our mail gateway. And I suspect following scenario: -> from: [email protected] Our gateway bounces because unknown sender (but passed after 10 minutes, I see always

Hello Tony, thanks for looking. Its still not working. When i login with my *..*@p*...*.de account,?I see it was set back to Summary. I again received the unsubscribed message. So what you did, had

Alan wrote, "... they do have other parameter sets, h or y, ?and that requires conversion to S." I think you meant to write "and that allows conversion to S." I think Tony is still interested in the

It's strange, I use the @1, @2, etc. notation all the time and I very rarely see artefacts. It's essential when you need to use this feature in waveform arithmetic. -- Regards, Tony

While many devices do not have S, they do have other parameter sets, h or y, ?and that requires conversion to S. Finally direct measure of S may be required.?For the case of the 3904, either measure

Vlad wrote, " flat() and gauss() are also affected by the clock seed. " Thanks.? I remember experimenting with it to see if they were also affected, but that was a long time ago. Andy