开云体育

It's quite possible that the data sheet Figure 13 isn't based on the Spice model, but on measurements of actual devices? of superior, rather than average, performance. There is no way we can tell.

I uploadet screenshots of my simulation and appnote Figure /g/LTspice/files/Temp/BUK7S1R0-40H%20simulation.zip. Yes i am looking at figure 13, the thing that bothers me are the final

Thanks, but you should not have uploaded.RAW? and .LOG file. Now, I suppose you are looking at Figure 13 in the data sheet. If not, what are you looking at. I see the current in the voltage source Vs

I put it in temp file as you said /g/LTspice/files/Temp/BUK7S1R0-40H%20output%20characteristics.zip i meant AP note AN90034 wich is also in the .zip

Also, which Application Note do you mean? The Nexperia web site lists several.

We can't help much unless you let us see more of what you are doing. Upload your .ASC file AND all the other files required to run the simulation, but not .RAW? and .LOG files or pictures,? in a ZIP

I am having issue with simulating experia BUK7S1R0-40H PET LTspice model characteristics https://www.nexperia.com/product/BUK7S1R0-40H when simulating mosfet with exact same setup as it is in

That's a good clarification. Thanks. Andy.

A few days ago, John Woodgate wrote: After some thought, I think that you never could use the CTRL key, nor anything else, to make a wire not snap-to-grid.? I think wires and components can only

I am sorry.? In my waveform colour scheme, I used the resistor colour codes, but offset by 1.? Thus "Trace V(1)" was Black, "Trace V(2)" Brown, etc.? I had become completely accustomed to Black

Yes, that's why I wrote 'near'. For colouring traces, there is no use for '0', so it comes in useful for '10', and the other two colours are fairly easy to generate in the Settings.

IIRC, Black represents 0 on resistors. (Colour blind, but not _that_ colour blind!) My favourite R was Brn-Blk-Orn Donald.

On older versions, that did not work.? Attempting to "Drag" (old name for "Stretch") the exact corner without drawing the lasso first,?would Move the whole rectangle. Andy

Considered and done! Actually, no change needed, you can already do this by clicking an anchor, or node, or component—no lasso required. Apologies for this oversight in my instructions. mike --

Agreed. Apparently, hard to do it “the right way” because EZ has to serve 1000s of products that are not software, and those not-software products steer the ship. Believe me, I've tried to improve

That is essentially what I used too.? But I diverged somewhat from the resistor colour code sequence to make them more visible.??It is interesting that you use a light grey background for better

Now I have it the other way round, white for schematics (so they print out that way), and light grey for waveforms to get better colour contrast. I'd like the default colours to nearly follow the

I wrote: Sorry, I forgot to provide context.? I was referring to the UI of ADI's Engineer Zone, making it appear as if a new message post could not be completed without a schematic.? Requiring to

I don't have a Windows driver to print to JPG.? I can print to PDF, and can go from there to a JPG or GIF or PNG but it's cumbersome. I forgot to mention that I always use a white background on my

Well, the message seems to be an executive order, not to be disobeyed. Perhaps it could be re-worded, like 'If your question is about a specific schematic, it can't be answered unless you upload the