开云体育

Hi, Is anyone experienced with the LT1171 and LTSpice. Is the synchronization function implemented in the model? I am trying to make a negative buck regulator based on the circuit in the datasheet,

"What is your definition of high frequency? For some people, it is 1MHz, for others it might be 10GHz." By definition, high frequency means 3 MHz to 30 MHz. Even saying "GHz range" -- does that mean 1

tob.nagel wrote: "simple task: I want to simulate the circuit in the following picture:" Please don't send links to off-site file storage areas. Some of them are like computer viruses. They take

Hey, simple task: I want to simulate the circuit in the following picture: https://s31.postimg.org/cfx03t823/circuit.png https://s31.postimg.org/cfx03t823/circuit.png

Try a 2N918. Small signal, but I think it is in the built-in LTspice library. Jim James Wagner Oregon Research Electronics https://sites.google.com/site/oregonresearchelectronics/home

Shikha wrote: "Can any one suggest me high frequency BJT Transistor or MOSFET available for working with LTspice." What is your definition of high frequency? For some people, it is 1MHz, for others it

Hassan wrote: "I have found either the .lib file or the symbol !!! " That is good. The first thing to understand is that they are almost completely independent of one another. A symbol is just an

And your LTspice-related question is what? Regards, Tony

Hello Shikha, NXP has a lot of RF-transistors and they provide SPICE models as far as I remember. Others like Onsemi and Infineon have RF-transistors too. Best regards, Helmut

" ? rmoreno.phone" asked how to enter a table of measured values for her/his CCVS. Vlad might have had the table descriptions a little bit confused with respect to your question, because I think the

2n2857, 2n3866, AT 41485, HXTR5105...good luck... Frank [LTspice] <LTspice@...> wrote:

Dear all,Can any one suggest me high frequency BJT Transistor or MOSFET available forworking with LTspice.ThanksRegardsShikha

Hello Brad, Not at my computer right now so I can't check, but maybe you just need to go to the control panel and enable save (subcircuit) currents.

I am trying to make a negative buck regulator with LT1171, based on the circuit given on page 13 of the LT1170/71/72 datasheet. I am trying to add clock syncronization as shown on page 11 of the same

Hello! I want to understand the operation of a switch made up of a P_MOS and a N_MOS in parallels and how to assemble them to convert an analogical signal into a numerical signal.Help!

Write a message...

they look like they should work, but the don't, how can I add them to my CMP folder, that is what is the correct model layout. Thanks Jeff

Repeat your question. That saves anyone thinking of answering having to search for it. With best wishes DESIGN IT IN! OOO – Own Opinions Only <http://www.jmwa.demon.co.uk/> www.jmwa.demon.co.uk J M

Hi .. No one has a reply to my question? Thanks Brad

Hi Team, I need spice model for TSMF1020 and TEMD 1020 IR TX and RX part. Regards, Dhanabal T