开云体育

Duh! I meant 24.0.12. Too many version numbers for my brain to handle. -- Regards, Tony

Yes, I brought it up, and ADI have agreed that it needs to be fixed. I guess pixels are somehow smaller now than when Mike E wrote the code for the dots. -- This email has been checked for viruses by

Analog Devices claims the current version is 24.1.4.? They have not updated their LTspice downloads page yet.

I don't get any errors running the schematic that the OP uploaded. But I was running 24.0.15. When I try 24.1.4, then the errors occur. Umm...... However, I still don't get agreement between the

On Tue, Mar 11, 2025 at 09:11 AM, eetech00 wrote: > > On Tue, Mar 11, 2025 at 08:46 AM, Dennis wrote: > >> Yes, a click on a rectangles corner anchor does allow stretching directly, >> but the click

That might be the problem. A drag operation shouldn't turn into a move operation. If a drag operation has been selected, a click anywhere on the edge of a rectangle should drag the edge

I don't know if this was brought up...but I still can't see a schematic grid. I haven't been able to view the grid for many versions of LTspice. I use a light grey background but it doesn't seem to

Yes, a click on a rectangles corner anchor does allow stretching directly, but the click target is so very small that often the user clicks on one of the sides instead and then the operation becomes a

Hi There is a special model "BUK7xxxx-40H_LTspice.zip" that needs to be downloaded and used for the simulation in Fig. 13. There is a link in the app note that initiates a download. However, when the

I will try to ask manufacturer, thank you for help :)

It's quite possible that the data sheet Figure 13 isn't based on the Spice model, but on measurements of actual devices? of superior, rather than average, performance. There is no way we can tell.

I uploadet screenshots of my simulation and appnote Figure /g/LTspice/files/Temp/BUK7S1R0-40H%20simulation.zip. Yes i am looking at figure 13, the thing that bothers me are the final

Thanks, but you should not have uploaded.RAW? and .LOG file. Now, I suppose you are looking at Figure 13 in the data sheet. If not, what are you looking at. I see the current in the voltage source Vs

I put it in temp file as you said /g/LTspice/files/Temp/BUK7S1R0-40H%20output%20characteristics.zip i meant AP note AN90034 wich is also in the .zip

Also, which Application Note do you mean? The Nexperia web site lists several.

We can't help much unless you let us see more of what you are doing. Upload your .ASC file AND all the other files required to run the simulation, but not .RAW? and .LOG files or pictures,? in a ZIP

I am having issue with simulating experia BUK7S1R0-40H PET LTspice model characteristics https://www.nexperia.com/product/BUK7S1R0-40H when simulating mosfet with exact same setup as it is in

That's a good clarification. Thanks. Andy.

A few days ago, John Woodgate wrote: After some thought, I think that you never could use the CTRL key, nor anything else, to make a wire not snap-to-grid.? I think wires and components can only

I am sorry.? In my waveform colour scheme, I used the resistor colour codes, but offset by 1.? Thus "Trace V(1)" was Black, "Trace V(2)" Brown, etc.? I had become completely accustomed to Black