开云体育

Hi Everyone! I have already get the information that LTspice system was hacked. I can not access the File directory of LTspice. Because the Yahoo ask me *3 steps* to join the LTspice. But I can not

Hello AS: This is beautiful discourse great physics and engineering here! I will digest it well. Thank you. Regards, Berns B. USC Physics

Good morning, I'm glat to participate in yahoo groupe. I have a problem for looking for librery of Multiplxer DG406 I had used the LTspice, and I found ADG406, but the GND for this integret cicuit is

Ok. Thanks. Works now. The THD calculation needs to be run with the name that shows in the plot when you probe that point in the fourier directive. I think I did have an alias for OUT before that was

Hi, I am facing issues with the flyback stability. The flyback is the +28V to +5V converter. The +5V is inturn used to convert another supply to +3.3V and +3.4V(two seperate converters using LTC 1778)

A netlist node cannot have two names (one will be ignored). The jumper component is supposed to allow a net to be given a name for each side of the jumper, but only one will appear in the final

THD-prob (probable bug) demo is here http://tech.groups.yahoo.com/group/LTspice/files/%20Temp/ in this file. THD-prob.zip

Hi VB I use the universal op amp 2. You tweak the params to match youre device. Works Every time! Ditto for mosfets. Never use out side models / subcircuits if you can help it. Al D. -- AC2CL I do not

Ok - so the mail list version of the messages has a lag - live and learn - use the site or expect a delay i guess. Sorry for the duplicate.

Ah. Thanks. Rod wrote:

Hi ppl, I thought I would search for it - to test my abilities - I didn't find it. I am learning a fair amount by just reading this group and others troubles. So as my first reply to the group I will

Hi Tom. Try this. http://tech.groups.yahoo.com/group/LTspice/files//%20Temp/tomshong/ File: AM_Receiver-rs-01.zip What I changed. Set VC to constant 100 pf so we can see what's going on and changed R4

The LP339 device is an open collector output and expects a resistor pull up to the positive rail.

this was a while ago, but you can modify it appropriately from Jim Thompson *VO=NOMINAL OPERATING VOLTAGE *IO=NOMINAL STEADY STATE OPERATING CURRENT *RCOLD=FILAMEMT RESISTANCE MEASURED AT ROOM TEMP

Hi ppl, I thought I would search for it - to test my abilities - I didn't find it. I am learning a fair amount by just reading this group and others troubles. So as my first reply to the group I will

Hello, Thanks for this report. The power pin at the bottom should have a "-". I have reported now this bug to Mike. Please directly report this to LTC in the future, if you find a bug. The email

In message <k1gmpk+qhts@...>, dated Mon, 27 Aug 2012, afhockey623 <jxm1092@...> writes: Yes; if you look at the data sheet, you can see it needs + and - supplies. You can report this to

I've been using TI's TL081 model without any problems but created my own symbol, just copied something else and renamed it. Gordon --

Hello, Yes, the lower + terminal should be marked -. The models "test circuit" show a negative supply connected to that pin. Rick