开云体育

Don't have any other pictures handy, but not hollow rivets as is often seen. It is the head end of the rivets that hold the contacts.The rotary switch that tone control portion works fine, it is the

Looking at the S-40 schematic, the tone control doesn't have a variable resistance.? It is a four position switch tone control with a SPST AC power switch attached.? The half meg tone pot with power

The middle one

Guys , my memory is failing, but the contacts of most pots/switches that I recall don’t have visible rivets .. do they ?? But maybe some older ones do ? has anybody got a picture? I looked in here:

Sometimes the rivets won't take solder. Scrape both rivets and body. ?Try soldering a again?Sent from my Galaxy

I'll try a little solder on the rivets and lugs. From the plug to the first lug is OK. Nothing on the other side, switch is open at the rivet.

EmilYou didn't mention checking to see if the ON / OFF switch rivets are high impedance thus causing the switch to be permanently open.? You could connect an ohmmeter to the line cord? plug and use

The switch action is erratic. Contact cleaner has had no effect. I could jump the contacts and plug the radio in to a power strip, but if there's an organ donor radio out there with a good switch, I'd

EmilDoes the switch still "click" when turned to the OFF position?? If so, take a close look at the switch solder lugs on the switch wafer.? There should be a rivet on each solder lug that connects

I need a Hallicrafters part number 60A225 power/tone switch. That is the same part number for the power/tone switch in the S-40, S-40A, S-40B, S-85, SX-99 and probably several other Hallicrafters sets

Thanks guys, I thought he shut down and sold all his stock. Don't know where I got that idea. Walt Cates, WD0GOF https://wd0gof.com/Hallicrafters A majority of acceptance is not proof of correctness.

And again, another reason to go to Dayton! Bunch of our club members there now but I am still not up for the trip these days. My very first impression was "If you can't find it at Dayton, then it

Just call the Fair Radio Tel no.? mornings and around 1700.? The email still works as well. Just spoke with Phil, and he is pretty sure he has what? you seek.? Not today as he is in Dayton. Sorry,

Do you have a number or email for Phil? Walt Cates, WD0GOF https://wd0gof.com/Hallicrafters A majority of acceptance is not proof of correctness. https://wd0gof.com/bible-study/commentaries/

If I had to hazard a guess, "Cornelius Connie"? aka Ashley Hall, W7DUZ at KISS Electronics. They repair at lot of URM-25s Emil WD4SCZ

Call Phil and askmight still have a few in the remainsR

Does any know who bought Fair Radios stock of step attenuators for the URM-25? Walt Cates, WD0GOF https://wd0gof.com/Hallicrafters A majority of acceptance is not proof of correctness.

Thanks for the add David .

I just UPDATED the following 2 ads on QTH and thought that ops on this server could be the Better solution: SEE ATTACHED PIX: A S-76 RECEIVER on top at 46lbs with the right most large

Jim, you wouldn't happen to have the plate tune cap also? Walt Cates, WD0GOF https://wd0gof.com/Hallicrafters A majority of acceptance is not proof of correctness.