开云体育

Weighted flywheel tuning on my SX-25 and S-40a main tuning but not bandspread. SX-100 has weighted flywheel tuning on both main and bandspread. No weighted tuning on my SR-400A, nor the matching VFO.

Not the first, or the last, but my SX-42 sure has it.

Here's a question that is of general interest to me.? What was the first and last Hallicrafters radio (Receiver or Transceiver) that had a flywheel incorporated into the main frequency tuning?? I do

Hi Dwight, I may be leaving for New Mexico as early as Friday so should be there all next week. I need contact information or an address for the R-274 pickup. I may be able to make the pickup on the

Hi Dwight, Thanks for the wake up call. As recently as today, Pie Town still had snow/sleet in the forecast. Normally the snow melts off or evaporates in a day or two. There is nothing but dirt roads

Hope the picture of the s-meter helps? I'm having a problem with mine too. Unfortunately, I'm missing the entire range indicator (right side of the main scale), drive pulley, and pointer, along with

Hello Tom, Just checking in to see if you still plan on taking a trip to the observatory. Dwight

RichardThis 115 volt line voltage, back in the day, is a myth.? Just look at Riders Perpetual Troubleshooter Manual, Volume 1 circa

I only was listening to local AM radio on the bench, chunk of wire connected to antenna terminal. It sounds really nice. Band switch is a bit stiff, will work on that. All controls and switches

I always add an inrush limiter to the vintage gear. An ounce of prevention... you know. Jeep K3HVG

I have an excellent S-40B. I was incredibly fortunate to find this one so as to replicate my first operational station in 1959. It appears as-new. All the paper stickers still in place. I did re-cap

Very good Richard, but what all did you manage to receive, and how did it sound?? Good luck Sent: Friday, April 18, 2025 5:38 PM To: [email protected] Subject: Re: [HallicraftersRadios]

I had fun this morning. I started up my 1952 Hallicrafters S-40B receiver today, very carefully. I first cleaned the controls, then plugged in the receiver with my Variac and Dim-Bulb-Tester in line.

Nick, well maybe you can ask some SX-23 owner to take some pictures for you. Other than that, any reasonable meter is better than none at least for now . If you go to swaps, with a picture you might

I have a few edge wise meters in the junk box, I'll take a look at what I have and get back to you here. *K2WH Bill's QRZ Biography ( https://www.qrz.com/db/k2wh ) *

Don, The original is completely absent.? All I have are some pictures that I found online and one from a guy at ARF. I did verify that the meter drive circuit works by wiring up the meter from a

Yup! Get in line and good luck! You'll have an easier time getting a machinist to make you one! -- 73/Rick W7IMM __________________________________ All posts are created using free and opensource?

Nick, do you have any of the original meter ,or is it all gone? Other Hallicrafters meters of that vintage might be the best bet, but I know little[nothing] about the differences. Good luck, hope you

Thanks, guys.? Anyone know where to find one of these backward meters?? I've seen some posts around where people claim you can adjust a regular "left zero" meter to become a "right zero" using the

With no power it should be to the far right. After power up it should slowly move to the left. Walt Cates, WD0GOF https://wd0gof.com/Hallicrafters A majority of acceptance is not proof of correctness.