开云体育

I have an exceptional SR-400, all it needs is a new pa LOAD cap. I would really like to find an original. Its a nice radio that I would like to keep original. Walt Cates, WD0GOF

Thank you Dave. Enjoy your time at Dayton! TomW3TA

Manuals are spoken for. Dave KC3AM

They are yours Tom. I will put them in the mail when I get a chance. Dave KC3AM

Hi Dave,? I have both of those radios and could use some original manuals for them. I won't be at Dayton, but am somewhat local to you in Warminster, PA. If you don't get rid of them at Dayton, I'd

Working on a SX 43 and am wondering if others have run into this issue. I have reception on all bands but only when I connect my long wire antenna directly to the RF adjustment pot for the

Had a strong 60hz hum in my R-388 after removing and replacing the front panel. Couldn't figure out where it was coming from. Turned out to be a heater string returning to ground through the frame of

Nice work as always Paul! 73/jeff/ac0c alpha-charlie-zero-charlie www.ac0c.com

I have manuals that are free to good home, pick up at Hamvention HT-44 SX-117 Dave KC3AM

my xr2000 was restored by the expert on these radios works great use it more than my yaesu 1000 sounds better and dont need my henry amp anymore

Clark, Old post but I am wondering if you still have any of the back panels available?? If so, I am interested. 73 Bob WB9RHW

Roger, Just wondering if you ever completed this restoration?? Please contact me. 73 Bob WB9RHW

Steve, had the same problem with a 32S-1.? I used a pair of needle nosed pliers and squeezed the center contact connector fingers closer together. Worked fine.? k6lr?Sent from my Galaxy

I replaced the RCA jack with a BNC jack in My Heathkit rigs.? My Henry 1KD-5 amp also came with a BNC jack on the input side. 73, Justin B. - KI5GKD

Hi, I have a SR-150 which I am refurbishing.? The phono (RCA style) RF output jack is somewhat unreliable, even though it looks to be in good condition.? Is there an upgrade suggested to replace the

Bob, There was a fella on here that had several made and was selling them. I think I have an old back cover. If you don't get any responses let me know. You can have my old one. 73 dave wa3gin

Probably a long shot but I was wondering if anybody here might have a back panel for a P-2000 power supply that they would be willing to part with? 73 Bob WB9RHW

I have manuals that are free to good home, pick up at Hamvention HT-44 SX-117 Dave KC3AM

I just updated the following 2 ads on QTH and thought that ops on this server could be the Better caretaker: SEE ATTACHED PIX: A S-76 RECEIVER on top at 46lbs with the right most large

Much needed. Thanks very much!