开云体育

Dennis, Please just put them here, in this thread and I'll move them over to the new folder. I'd sure like to see you move your email over to a gmail account or so such, since then it would be removed

Dennis, I'd be interested in one of your spindle thread protectors if you still have some available.? How do we go about getting funds and info to you? Would also be interested in thread dials if you

From Dennis Turk about shipper losing parts forever; That's how I felt when a trucking company broke rare machines they were shipping. " Bastards you know how rare Dalton 9 parts are.? Grrrrrrrr"

Lot 6 and Dalton 9 thread dials. Dalton used the same dial body shaft with face as well as the mounting bolt on all models of Dalton lathes. What was different was the gear. Lot 6 and Dalton 9 lathes

" if you make some, I’ll take one for sure." Thanks for the encouragement Glenn. wrote:

This is most interesting. What I find so interesting is the thread dial looks very close to the Dalton one in design. Meany thread dials use a straight cut gear and angle the body or the vertical gear

I don't? know if this info is useful, but I'll put it out there. The Grizzly 602 lathe has a 12tpi lead screw if my research is accurate.? They also offer a thread dial.? To be clear, this is not a

Problem is there was no Daltons built with that size lead screw. Sent: Monday, December 27, 2021 6:39 PM To: [email protected] Subject: [DaltonLathes] Dalton 6" Type B-6 Metal Lathe Thread

Hi Joe I shipped the guy the worm gear with clutch shaft and knob I may still have the worm and its mounting casting. Will have to take a look tomorrow. I also sold this guy the cone pulley with the

DanLins <linscheid.dan@...> added folder */Threading Dial dwgs - Dennis Turk*

https://farmboysales.com/products/dalton-6-type-b-6-metal-lathe-thread-threading-dial

Dennis: I may be the fellow you sent the clutch to. From what you said I thought that you may have had a complete apron besides what you sent me. I am just missing the worm gear that mounts on the

Glen, Re threading dual: if you make some, I’ll take one for sure. Glenn Brooks

Yes Dan Sent: Monday, December 27, 2021 4:23 PM To: [email protected] Subject: Re: [DaltonLathes] Getting back to my Dalton Dennis, is it OK if I put these drawings in our files section? Dan

I suspect they may have been intentionally removed. Perhaps the machine was "surplus " at the shop where the previous owner worked. By the way. I made a first cut a few minutes ago. Nice and quiet. I

That would be perfect. John Molburg wrote:

No numbers on the very end of the bed?

Dennis, is it OK if I put these drawings in our files section? Dan

This is a picture of the nose protector on a lathe but before I had them black oxide coated. John also note the oil cup for the spindle bearing. This is what yours would lave originally looked like.

I also have a box full of spindle nose thread protectors if anyone wants on. Usually ask $25 and shipping but if anyone wants on you can have one for $20. Should ship in a small flat rate box that’s