开云体育

This is the setup I am trying to use now.? All software is current.

dxl is using flexsig and slicemaster is using whatever it uses to connect to ssdr.?? Seems to set WSJTX to HRD for the rig on port 7832.

?

it all seems to be working ok after some trial and error with manuals.? but if i click a call in wsjtx the call info does not populate dxk or its capture window.? so i dont get any info until the qso is over when wsjtx does send the entry to dxk.?

?

Also when the wsjtx spots go to spot collector, If i click on one? it changes slice A to the spot freq even though i was on slice B.? So it causes an interlock issue trying to TX on the same freq for both slices.

?

Thanks!!!

--

?

73,

Greg - AB7R

?

Flex 8600

PGXL & TGXL

AG

+ AA6YQ comments below

This is the setup I am trying to use now.? All software is current.

dxl is using flexsig and slicemaster is using whatever it uses to connect to ssdr.?? Seems to set WSJTX to HRD for the rig on port 7832.

?

it all seems to be working ok after some trial and error with manuals.? but if i click a call in wsjtx the call info does not populate dxk or its capture window.? so i dont get any info until the qso is over when wsjtx does send the entry to dxk.?

?

Also when the wsjtx spots go to spot collector, If i click on one? it changes slice A to the spot freq even though i was on slice B.? So it causes an interlock issue trying to TX on the same freq for both slices.

?

+ There is no interoperation between DXLab and SliceMaster.

?

+ There are two supported forms of interoperation between WSJT-X and DXLab: direct, and via JTAlert. See

?

? ? ?73,

? ? ? ? ? ?Dave, AA6YQ

Thanks Dave.? I will bypass Slicemaster and see how it goes.? Appreciate the assistance.

?

--

?

73,

Greg - AB7R

?

Flex 8600

PGXL & TGXL

AG

I think I got it.

?

Is there a way to make a selected spot go to the slice set for TX instead of always going to A?

?

--

?

73,

Greg - AB7R

?

Flex 8600

PGXL & TGXL

AG

+ AA6YQ comments below

Is there a way to make a selected spot go to the slice set for TX instead of always going to A?

+ When Commander is interacting with a Flex Signature transceiver, simplex operation utilizes Slice A for both RX and TX. Split operation uses Slice A for RX and slice B for TX.

+ If you double-click a Spot Database Entry that specifies a QSX frequency extracted from spot notes, then Commander will be directed to enable Split, the Entry's frequency will be sent to slice A, and the Entry's QSX frequency will be sent to slice B.

? ? ? ?73,

? ? ? ? ? ? ?Dave, AA6YQ