开云体育

-----Original Message----- From: dxlab@... [mailto:dxlab@...]On Behalf Of k4pby Sent: Friday, September 04, 2009 3:14 PM To: dxlab@... Subject: [dxlab] Re: CW

Hi Mike, I take it from your description that you are using WinWarlber to generate CW rather than an external keyer such as the WinKey. Unfortunately, code generated by WinWarblerr is subject to CPU

Hi Dave---It is configured Parallel Port (LPT3 Data 5 pin 7)

On the Config window's CW tab, which option is selected in the Keying panel? 73, Dave, AA6YQ

To recover your wayward Configuration window, see <http://www.dxlabsuite.com/dxlabwiki/RecoverWindow> Uninstalling and re-installing a DXLab application almost never resolves the underlying problem,

FYI This problem I'm Haveing is only happening on my laptop. my home units are working just fine. I went to look up info on the other units to see if I had something missing ( ie; Program files )

Hi Group I have been a member of the group for quite sometime. have enjoyed reading about the shortcuts and fixes. Now I have a problem with my DX Keeper Config. Application Pages. When I click the

Hello--I am new to the group. I am using WinWarbler ver 4.5.0 and have been very pleased with it. I have one problem that I am trying to solve though. When operating CW someties characters get run

I agree with Rich that you should upgrade to the latest release of Commander, but I doubt it will resolve the problem. You report that Commander was successfully controlling your transceiver, but that

There's a scripts folder in this group's Files area. Anyone can upload scripts they wish to share, and anyone can download them. 73, Dave, AA6YQ

Sounds like a problem with the Signalink driver, Mark. I suggest contacting Signalink's technical support. 73, Dave, AA6YQ

WinWarbler cannot use QRZ.com as a callbook unless both DXKeeper and Pathfinder are running, and the Callbook tab of DXKeeper's Config window is configured for "QRZ.com via Pathfinder". As a result of

--- In dxlab@..., "ke7ace" <ke7ace@...> wrote: when i hit the look up from dxkeeper it brings back the info from qrz but the name and part of the address is all just mixed letters and

when i hit the look up from dxkeeper it brings back the info from qrz but the name and part of the address is all just mixed letters and numbers just noticed this starting this past week not sure

yes it would be nice.. lot of work has been done by a lot of the guys on SQL's . Drop me a card to p.o. box 131 Ferguson Ky 42533 and ill get you a qsl asap. just a sae is all i need. will save a lot

The problem you describe is not a familiar one but the latest version of Commander is 7.9.2. The version 5.8.7 you have is a couple of years and two major revisions out of date. So, first get the

Hi Tony, That would be a very useful resource. I have to confess that my knowledge of SQL is not very good & it would be very useful to be able to refer to an index rather than keep asking for help. I

Hello to all! I downloaded and installed Commander 5.8.7. as a standalone. It was working perfectly in the beginning. I am using it mainly for tuning and saving the frequencies for my Yaesu FT-897.

does anyone keep a list of all the scripts that have been written over the years for dxlab ? got another station up and going this week. hope to get the last one next week then network all 5 computer

I have a problem with WW receive. TX works OK. I am using a Tigertronix Signalink USB interface. I had it working up through last night but when I turned on the computer this morning RX doesn't work.