开云体育

Yours is probably fixable. With a little careful filing, you should be able to make the "V" fit against the "V" on the bed. Once they match, you might need to install a shim between the upper & lower

Here are the dimensions: http://littlemachineshop.com/Info/lathechuck.php Roy

Alan a very good summary in my opinion. Can I also suggest you could go one step further and buy a battery bank, a charger and a DC to mains inverter. This way you could have a bank of batteries as

I think this description could be confusing. The usual sort of "UPS" sold for use with personal computers passes the mains current through to the computer while maintaining a floating charge on the

{note: some people list the stabilizer function as a regulator or automatic voltage control } The voltage stabilizers from APC are about $40 delivered for 1.2kW. These adjust for over/under voltage

I can make you one, if you want. I have replaced that part on all my 7x lathes with one that will stay aligned. $25 postpaid in the US. I have also converted the TS on my lathes to lock with an

it is locking down properly, but in one case it locks ok, in other its a few degrees to the left. I've checked the V groove, its not aligned from the side thats closer to the chuck.

That's the same as we have, and there is a 10 second auto delay before the generator cuts in, so as to give time to differentiate between a mains dip and a power cut, the genny runs until it is

Are you sure it is messed up? It is possible to rotate the keeper plate 90 or more degrees and then it won't lock down properly. Check this out before replacing! Bob

just to add, mine lathe is Einhell MTB 3000

Hi, my lower casting on tail stock is messed up. Don't know how, but it wiggles, and its hard to align it right (V is damaged). I have asked LMS do they sell just that part, but unfortunately they

How expensive would a really good one be? Mert

With the online UPS, you're actually running on the UPS 100% of the time. The "mains" only power the battery charger(s) to maintain the batteries. I have an online UPS. It stands approx 5' tall and

In article <1352244922.96348.YahooMailNeo@...>, John Kiely <john_kiely@...> wrote: The way a UPS works isn't down to manufacturer, there are two basic type of UPS 1) The

Hi Roy I've only tried the kitchen oven a few times and didn't notice it lingering but that might be down to the powder I used and a separate oven is a far better idea. People regularly dump ovens

Harbor Freight came through for me, but it did take about 3 months. In the end I got everything I needed to complete my 7x10 floor model purchase for free, no questions asked. From:

<Snip> Sorry, I need to wake up fully, that was how to drill holes in an adaptor plate to mount it onto the chuck but you already have those. A similar principle of drill and rotate can be used in

In article <k7ckgm+firm@...>, paul.consolini <consolinipj@...> wrote: Mount your chuck on your drill press, minus the adaptor plate (I assume you have one) and use a drill to

Sounds like a good plan. The registration recess is the important bit; that's what sets the chuck concentric to the spindle. That said, if the chuck is an independent 4-jaw, the work will need to be

That is correct. Hope it works out for you.. you'll get a million+ responses saying it didnt work for them.. (but it did for me.. and a few others) I ordered mine long ago.. and the shiping took