开云体育

Oops. In my last post I had a type for the Little Machine Shop home page.? It should be?http://www.littlemachineshop.com Charles E. "Chuck" Kinzer

Hi Dave I have LMS 5100 lathe catalogue in .pdf format, want it ? /johannes Sent: laurdag 9. mars 2024 11:47 To: [email protected] Subject: Re: [7x12MiniLathe] Vevor parts If need parts try

IF it is actually a Sieg manufactured lathe (or close to it) the "Little Machine Shop" may be able to help. This is a Sieg C2 Diagram somewhere at their site.? I don't know how to find it within

Grizzly is my go-to source for mini lathe parts, although I have no complaints with LMS. Grizzly sells a 7x12 and a 7x16. Part numbers for the (presumably) common parts between them are different and

If need parts try little machine shop. I am same boat if tooling or part it is hunt surprising I can find all tooling and parts i need. Dave

That is a on going problem with parts list. This may help . I got it from someone else that got it from Vevor with lot of trouble. Dave

The Vevor 7x14 lathe I bought has no parts list and does not always match what is on other mini lathes. The quality of the parts has not always been the best. The keyway in the shaft for the "A"

Hello, Mike! Do you have access to a Deckel type tool grinder? If not you could easily make a simple jig to do this. Of course this would not be a quick solution but you would then have this jig for

I also use the bench grinder for drill bits too. I have been so long I forget the pain of learning.? All I had was bench grinder. Dave

I have seen few over years. All I use is a 6" bench grinder. Dave

(I realize this is a minilathe group, not a shaper group, but there are shaper owners on here, plus many ingenious people, so I'm forwarding this post I sent to a shaper group). One advantage of a

Machining a strait knurl is an easy and clean way to produce a knurl. It does however require a means of dividing such as using a dividing head of some type. If one uses this method it is good to not

Knurling is ?“not” a cutting operation but a forming operation. Keep that in mind. Too much swarf is an indication of not enough force being applied and doesn’t produce a clean knurl.

stuck at the wrong heigth by some chips ?

The work diameter should follow the rules here: < https://littlemachineshop.com/reference/knurler.php > for the cleanest knurl. On the 7x lathes, a scissor type knurling tool usually gives better

Pull the knurl wheels a measure them . Knurling takes a lot of pressure & sometimes? much more pressure then ya would think to make a good knurl .Pressure also varies depending on the material yer

It appears that one knurl is engaging deeper than the other. This one direction gives a doubled knurl and the other a correct knurl. wrote:

I agree with OldToolmaker You need cutting and aggressive. Watch videos on screw machines doing knurling. Dave

For successful knurl use the following steps. 1) Use cutting oil 2) Position the knurling tool as close as possible to headstock. 3) Switch lathe on and advance the knurling tool into the cut as

I made a knurld ring on my brass knob. but, as the result, something wrong with the knurld surface. it's not even crossing each other. How can i solve this ? i turned on my lathe with 240 RPM and fed