开云体育

I did smoothing similar years ago, but I only had a 1-inch travel dial indicator.. What I have found to be really useful in conjunction with the dial indicator is an adjustable stop between the

Loads fine here too. It's a shame that if you wanted yet another O-scope you'd have to move into a larger shop space. ? Michael - California, USA Micro-Mark MicroLux 7x16 LMS 3990 Hi-Torque Mill

There is a mini mill group right here in groups.io but the last message I see in it is from 8/19/2021. Most just post here for mini mill questions. It’s up to the moderators to control it. I like

Hi Ryan, I opted for the "poor mans DRO"on the X axis of my lathe. I made up a simple clamp that allow me to use a 2" dial indicator against the carriage to measure travel. Cheap and easy to

Loading for me here in north VA

https://www.youtube.com/watch?v=nLEnmzJDLtE

Hi Floyd, Not having installed that exact kit, I can't say for sure, but I did install the metric lead screw conversion kit and there was little to no discernible difference in backlash between the

https://training.ti.com/demystifying-bldc-motor-commutation-trap-sine-foc

Not quite 3 phase as you know it. It's a BLDC drive based on the Microchip/Atmel BLDC Sensor-based reference design:

Went to that mini-mill forum and I'm a member. So I sent a test notification to my browser and didn't get it. I guess I need to play with it a bit until I get the notifications. My mill has the

The control board not only changes 120V to 230V, but it makes it 3-phase too. The marvel of electronics, which I do not understand. The Fault light indicates an error condition. In your case it may be

I? own a Micro-Mark benchtop mill and it came with Imperial lead screws and nuts.? Of course it had backlash -- all feed screws of this type do -- but it's been very usable.? The X axis is better

I was on the mini mill yahoo group. It was a long time ago. Maybe someone here can answer this question. If its not appropriate here please let me know and accept my apologies. I have done a lot of

WAM ; Do you have problem with your web? I have tested you With different browsers Hmm. We’re having trouble finding that site. We can’t connect to the server at www.ajawamnet.com. Sendt fr?

There used to be a Yahoo group called something like “GrizHFminimill” (I probably don’t have that quite right and all brands were discussed) which was pretty good. But I think it evaporated. I

I was wondering where I might find the Mini Mill forum. I'm not sure this is the forum to discuss the mill on.

Hi Jon, I am just an occasional user of the lathe, mill and band saw. The motors have all performed excellently. I use the foot pedal on the mill and bandsaw with a 100k POT on the lathe for speed

I have the Consew on multiple machines - my CNC and my Deckel clone: http://www.ajawamnet.com/ajawam3/swarf/maxnc.html http://www.ajawamnet.com/ajawam3/swarf/cutter_grinder.html On the one I have -

-- Since I have just been cleaning and painting a steady that was given to me for my Boxford A lathe, your post caught my attention. I like the big open gate at the top. It bolts onto the ways with a

Hi all. For my next lathe project I'm thinking about adding an X axis DRO.? It's really the one axis there's no built in measurement for and I think I'd really like it for boring to a specific depth