¿ªÔÆÌåÓý

Re: lathe height


Jerry Durand
 

¿ªÔÆÌåÓý

Lathe should be about elbow height...more or less to personal taste.

On 02/05/2013 05:47 PM, Ebner Heating Air Conditioning Co. wrote:
I'm getting a heavy bench set up to accept my lathe. After bolting a heavy set of casters that were sized to accept the 400 pound weight I ended up with a bench that is to high to comfortably work while sitting on a stool. My question would be is there a rule of thumb 'height wise" that?I should shoot for? I don't want to cut the legs off so that the bench ends up to low.
?
Thanks Mike


-- 
Jerry Durand, Durand Interstellar, Inc.  
tel: +1 408 356-3886, USA toll free: 1 866 356-3886
Skype:  jerrydurand

Join [email protected] to automatically receive all group messages.