开云体育

HF Bandsaw Help needed [1 Attachment]

Ralph Hulslander #14732 How exactly, step by step does one disassemble the gear box? Who knew you were supposed to check the gear box grease/oil once a year? Now I need to replace the gears but do not knw where to begin! Ralph toggle quoted message Show quoted text On Sun, May 19, 2019 at 7:35 PM mike animal@... [4x6bandsaw] <4x6bandsaw@...> wrote: ? [Attachment(s) from mike included below] ?? evening folks . I have a HF 62377 that I bought used , I opened it up to chek the oil & to no surprise there was none . so I dove into it & the seal was wadded up wrapped around the shaft under the Brass gear ??? ??? on the drive wheel shaft , the manual show's different I cant find the pic's I took with a different camera when I took it apart , so here's a few pics of my parts & hopefully one of you pros can give e a nudge in the right ??? ??? direction . I have the seal, shaft with a cir clip , (which does not show in the parts list ) 2 bearings , 1 what looks like a spacer for between the bearings or between 1 bearing & the seal ? & a spacer t. I'm pretty sure that ??? ??? these parts all came out of the? machined cavity (that the bearings & seal fit into ) between the retainer with the 3 screws & the bronze or brass gear on the driven shaft in the gear box , I'm just uncertain of the ??? ??? order they go ??? ??? tks ??? ??? animal
Nobody Knows All Messages By This Member #14738 When you are finished with the gear replacement, you can make a plexiglass or acrylic gear box cover so you can see the oil level.? I did this an placed a 1/4" bolt towards the top that can be unscrewed to add more oil if/when needed.?? See picture of mine:??

Previous Topic Next Topic