开云体育

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the 4x6bandsaw group. File : /Blade Welders, Electric/2005_0928-Harbor Freight Blade

Hi Bo The tension block that carries the driven wheel's axle is loose on its guide rails in most saws I've seen. I reversed the rails (so the slots in the axle block run on the other side of the

I purchased my HF 4x6 saw (green one) in 2004. Outside of blade (bi-metal) changes, all still runs great. I've cut 10-inch steel "I" beams, various other steel, aluminium, brass, and stainless shapes.

Well, I was cutting a big chunk of aluminum, and I didn't grab it in time, and... jam... And it looks like some stuff has come loose. Now, I must confess... I bought my first HF 4x6 back in 2012, and

I have had better luck using a 1/4 or 3/8" scarf joint and 45-55 percent silver solder.? I've never had a joint fail. Sent from my Verizon 4G LTE Droid

Thanks for the time and effort put into the response.You have fully described and put down a great narrative of the function.Mine works mechanically differently, but not an issue to the fundamental

Photo 2

Photo 3 Sorry about this, don't know why its acting up

Photo 3

Photo 2

Photo1 I sent all 4 in the reply but only photo 4 came thru. Will send others as separate posts

Hi Peter If you want to get it going again I suggest you take it to a local welding supply/service place, as I did with the one pictured. There'll be one in almost every city. They told me a blade

I have been donated a butt welder that has been stripped from a large wood shop bandsaw, that was scrapped. No manufacturers ID and look like low volume build from the marking blue on the castings.

Hi all Just discovered a welding fault that's probably quite common, but it threw me for a bit until I figured out what was going on. I cut through a piece of 4x1 joinery timber standing upright in

Consew DC Brushless motor <https://www.ebay.com/itm/NEW-Genuine-CONSEW-SERVO-MOTOR-CSM1000-FOR-INDUSTRIAL-SEWING-CS1000-3-4HP/151686851628?epid=24010157335&hash=item23513dac2c:g:mLoAAOSwl8VcrsIV> yes

Main thing is cost.? The Consew comes with the controller and isn't very expensive.? I used one on a grinding table I made for someone and have another to put on my milling machine. And for those in

What are the tradeoffs of the brushless DC setup vs a small 3-phase motor + vfd? [4x6bandsaw] <4x6bandsaw@...> wrote:

JV - You really went above and beyond with your explanation and drawing to help out another group member! That's what I love about this group and a couple of others that I'm a member of (machinery and

Or while you have the existing metal cover off, drill and tap it for a filler & level plug. Robert Downs Sent: Tuesday, May 21, 2019 21:55 To: 4x6bandsaw@... Subject: Re: [4x6bandsaw] HF

Ralph Check out this guy, he direct mounted a motor on a 4x6 and did away with the gearbox altogether, mounted it off a thicker cover plate by the look of it, about minute 25:00 in the clip. Stephan