?

Hi there group,? I just picked up a nice little super in good shape Grizzly G1010 4x6 from a lady whose husband passed away.? Got it super cheap..? He was a wood worker and used it to cut wood only.? The saw is complete and was kept covered when not in use.? The only thing that was disassembled was the two guide bearing assemblies.? I purchased 6 new 6000z bearing and installed them on the shafts and saw that two of them were concentric for adjustment.? My question to anyone who can help is where do they go?
If you are standing in front of the machine looking at the Grizzly nameplate on the left and motor is on the right in horizontal cutting position.? Do they go in front of the blade or behind?? Or does one guide get one on the front and the other guide get one on the rear of the blade?? I’m stumped???????? Need some help getting this little metal slicer up and running!!!!

? One on each end , put them both on the same side of the blade . Then adjust for about .006 - .010 chip clearance between the blade and guide bearings . There are a couple of good articles on alignment in the archives unless yahoo has managed to lose them .

? To the group owner - have you considered moving the group to IO ? Several other groups I read have made the move , and are better for it .

? --

? Snag